Charlie
I queried this note about the National dump cars with Hol as it also appears in
Bulletin 25. We concurred that there is no record of any National dump cars being
built for the Burlington in 1914, so the date is wrong at the very least.
(Quoting from our correspondence) Working backwards from 1914, there were 50
Kilbourne & Jacobs (truss rod, 29’ 5”) 100 cars built at Aurora
in 1907 (truss rod 33’ 7”), then the Ingoldsby ones in 1905 (truss
rod 42’ 6”, but I think they lasted until at least 1939) and before
that is a bit of a mystery. I realise that truss rods could be used with steel
underframes or sills. However, none of these appear to be a suitable candidate
to provide steel underframes for the SM-18’s, any underframes would
require welding or cutting for the 36’ 4” stock cars,. It’s a
pity that company service equipment wasn’t fully recorded in ORER’s
– research would be much easier.
If anyone can throw some new light on possible National dump cars, we’d
be very grateful.
Rupert Gamlen
Auckland NZ
From:
CBQ@yahoogroups.com [mailto:CBQ@yahoogroups.com]
Sent: 25 July 2015 06:49
To: CBQ@yahoogroups.com;
STMFC@yahoogroups.com
Subject: [CBQ] CB&Q 36 ft
Single Deck Stock Cars
A while back Rupert
and others were discussing CB&Q Steel frame stock cars.
I was looking for
something else and came across an Ownership, Age & Condition document from
the CB&Q that states in part:
Nos.
Blt.
#
Condition
55950-57449
1926-28 1262
Fair
In building these cars steel center sills from old National dump cars built in
1914 were used.
Series 58000-58999
built in 1924 and 59000-59499 built in 1922 do not have this notation and were
presumably built with new center sills.
Charlie Vlk
Posted by: "Charlie Vlk"
<cvlk@comcast.net>