BRHSLIST
[Top] [All Lists]

Re: [CBQ] Helper ops

To: CBQ@yahoogroups.com
Subject: Re: [CBQ] Helper ops
From: "Jpslhedgpeth@aol.com [CBQ]" <CBQ@yahoogroups.com>
Date: Thu, 24 Aug 2017 22:38:49 -0400
Authentication-results: mta1005.groups.mail.bf1.yahoo.com from=aol.com; domainkeys=neutral (no sig); from=mx.aol.com; dkim=pass (ok)
Delivered-to: unknown
Delivered-to: archives@nauer.org
Delivered-to: mailing list CBQ@yahoogroups.com
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=yahoogroups.com; s=echoe; t=1503628731; bh=0AvTDBUB29gmF7inIYXAu0msIIht1JbAd5WqA/x483c=; h=To:In-Reply-To:References:From:List-Id:List-Unsubscribe:Date:Subject:Reply-To:From:Subject; b=H6A3LKFNl15vNg7XDd3NXRWNVcjDXPC3R0PzMql13Q1z19VyssYdPmbHeGJ/TrwE9D4GdO9wZIVyMT+ZybHwx0LPgfGCPjQOOtpdn9unqGJWuZ2pgLmwz8flKa4gkPUvnDzRac9085xNHG5hXeGK7rvSXEO8CPB0It/QrBjF8FI=
In-reply-to: <422932.7a4d0c18.46d09657@aol.com>
List-id: <CBQ.yahoogroups.com>
List-unsubscribe: <mailto:CBQ-unsubscribe@yahoogroups.com>
Mailing-list: list CBQ@yahoogroups.com; contact CBQ-owner@yahoogroups.com
References: <422932.7a4d0c18.46d09657@aol.com>
Reply-to: CBQ@yahoogroups.com
Sender: CBQ@yahoogroups.com


Louis..I don't think helper whistle signals as you described them would be anything different from those prescribed by the standard Book of Rules for the use you specified..I can't why signals to do what you outlined would be different for a helper than in any other service.

Pete


-----Original Message-----
From: LZadnichek@aol.com [CBQ] <CBQ@yahoogroups.com>
To: CBQ <CBQ@yahoogroups.com>
Sent: Thu, Aug 24, 2017 3:51 pm
Subject: Re: [CBQ] Helper ops

 
August 24, 2017
 
Group - Was West Burlington Hill the only regularly assigned helper district on Lines East during the steam era? Does anyone know what the steam whistle signals were such as go ahead, back off, stop..... Best Regards - Louis
 
Louis Zadnichek II
Fairhope, AL
 
In a message dated 8/24/2017 1:00:30 P.M. Central Daylight Time, CBQ@yahoogroups.com writes:


I've done some of that stuff.  One afternoon, I shoved a freight train over Newcastle with my 'hopper' without cutting off, or 'cutting in'.  Like you say, it could have been messy, but wasn't, he really didn't take much shoving.  I've had the Belle Ayr helps cut off on the fly with the crew on the waycar, and no air cut in. Sometimes they weren't even coupled, just pushing against closed knuckles. 

If you helped another train on the road, it paid time or miles, whichever was greater, with a minimum of two hours (25 miles).  The time started when you were notified by the Dispatcher that you would have to cut off to shove them, and ended when your train was moving again.  The miles were counted from where you cut off to where you cut off the train you were shoving, and back again.

In reference to the original question, I've always read that with steam helpers, the helper would try to start the train first, then the road engine would start pulling, though Karl would probably be in a better position to comment on that.  The principle was that the Helper was 'bunching' up the slack, so that the Road engine didn't have to start the whole train at once.  The two Engineers would communicate by whistle signals.  The helper had the automatic brake valve cut out, with what was commonly called the 'double heading cock'.....though the instructors at BNU in St. Paul would loudly inform you that it was properly known as the 'brake pipe cut out cock' :>)

Mike



__._,_.___

Posted by: jpslhedgpeth@aol.com



__,_._,___
<Prev in Thread] Current Thread [Next in Thread>