Re: [CBQ] Merry Christmas from Rapido

["Dave Lotz via groups.io" <Dave_Lotz=bellsouth.net@groups.io>]

All,

 

As you have seen in this thread, even though the BRHS does not have a V.P. of Projects, there are folks like me and Bryan who have established relationships with manufacturers, and when we know about  a Burlington project, we work closely with them to try to get them to do as accurate as possible models. Whether or not they listen is not in our control. Because we work with any manufacturer to provide data, we are not at liberty to always “talk” about those projects until a certain point in the process.

 

Dave

 

From: CBQ@groups.io <CBQ@groups.io> On Behalf Of Bryan Howell via groups.io
Sent: Thursday, December 25, 2025 7:46 PM
To: CBQ@groups.io
Subject: Re: [CBQ] Merry Christmas from Rapido

 

Leo, 

 

I was planning on reaching out to them again after working on the E8/9 project with them. The later runs of the E8/9s have smaller grab irons on the nose, but I'll have to triple check with them on the ladder grabs on the roof. I'm pretty sure I pointed that out to them previously, but will do so again. I can also advocate for a road number or two with black stripes in the first run.

 

Bryan J. Howell

Superior, WI

 

Virus-free.www.avast.com

_._,_._,_

---

Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#67969) | Reply to Group | Reply to Sender | Mute This Topic | New Topic
Your Subscription | Contact Group Owner | Unsubscribe [archives@nauer.org]

_._,_._,_