Re: [CBQ] Question on BREX Refers

["Rupert Gamlen" <gamlenz@hotmail.com>]

Bill

Thanks for this advice. I must confess it is a long time since I read that Bulletin.

Rupert Gamlen
Auckland NZ

 

From: CBQ@groups.io <CBQ@groups.io> On Behalf Of Bill Glick
Sent: Sunday, 5 July 2020 12:22 pm
To: CBQ@groups.io
Subject: Re: [CBQ] Question on BREX Refers

 

Hi Rupert

 

I questioned that but I chose to put doors on both sides.

And after I finished the model a person on line mentioned that there

was an REFER subject in Bulletin #12.

So when I looked at that issue I see this reference (see attachment).

It states that there were two doors and two doors.

So now we know, and that makes my model correct.  I also made the under charge with

a lower center beam as shown in the original photo, but not seen in model photo.

Bill Glick

 

From: Rupert Gamlen
Sent: Saturday, July 4, 2020 2:21 PM
To: CBQ@groups.io
Subject: Re: [CBQ] Question on BREX Refers

 

Bill

Did you put a cream section on just one side of the car or on both. The only photos I’ve seen of this car are all of the same side so there was speculation if the other side was the same.

Rupert Gamlen
Auckland NZ

 

_._,_._,_

---

Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#59890) | Reply To Group | Reply To Sender | Mute This Topic | New Topic

Your Subscription | Contact Group Owner | Unsubscribe [archives@nauer.org]

_._,_._,_