[CBQ] CB&Q Steam Loco Tenders

["brucec34rr" <brucec12@comcast.net>]

I am scratch building a CB&Q G-3 0-6-0 (which was converted to oil). I am 
trying to determine if the water tanks rear deck was flush with the sides or if 
the sides extended up past the top deck (as I think was typical of most 
railroads). The question came up as the top horizontal rivet line is very close 
to the top of the side (and closer to the edge than I see on other railroads) 
which would indicate that the top deck had a flange bent down to rivet(and 
making it ~flush with the side). Unfortunately, I can not find any clear 
pictures of the top of CB&Q tenders, most are from track level and the 3/4 
front of the loco! 

Hope this is clear and thanks for any help,

Bruce Collins 



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/CBQ/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/CBQ/join
    (Yahoo! ID required)

<*> To change settings via email:
    CBQ-digest@yahoogroups.com 
    CBQ-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
    CBQ-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/