Cut the glazing just a little oversize and fasten it to a toothpick with
Micro clear. After the micro clear sets up add a little micro clear around
the outside edges and slide the glazing into the opening and adjust to fit.
Hold untill the micro clear sets up. The next day you can pull the toothpick
off.
-----Original Message-----
From: magichammer2 [mailto:magichammer2@y...]
Sent: Saturday, November 09, 2002 9:35 PM
To: BRHSlist@yahoogroups.com
Subject: [BRHSlist] model question
I have a question for the modelers on the list. I'm finishing off a
brass Oriental Import of Silver Dome and am running into a little
problem getting window glazing in the end doors in the vestbule.
Seems the manufacturer didn't leave any way to access the interior of
the vestibule, so you can't simply glue the glazing in.
Near as I can figure my options are:
Cut an opening into the vestibule bulkhead or car end so I can access
it and glue the glass in. I hate the thought of putting my dremel to
this nice car.
Use micro crystal clear of which I don't like the results,
Leave the glass out.
Any other suggestion out there?
Greg in MN.
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|