Re: [CBQ] Speaking of Shovel noses..

["Dave Lotz via groups.io" <Dave_Lotz=bellsouth.net@groups.io>]

Brian,

 

That’s how I did my MTZ.

 

Dave

 

From: CBQ@groups.io <CBQ@groups.io> On Behalf Of BRIAN PAUL EHNI via groups.io
Sent: Thursday, June 11, 2026 4:24 PM
To: CBQ groups.io <CBQ@groups.io>
Subject: Re: [CBQ] Speaking of Shovel noses..

 

Guess I wasn’t persistent enough. I’m guessing that the installed PC board has to go so all wiring is thru the decoder?

 

 

Thanks!
--

Brian Ehni

 

 

From: "CBQ groups.io" <CBQ@groups.io> on behalf of "Dave Lotz via groups.io" <Dave_Lotz=bellsouth.net@groups.io>
Reply-To: "CBQ groups.io" <CBQ@groups.io>
Date: Thursday, June 11, 2026 at 3:10 PM
To: "CBQ groups.io" <CBQ@groups.io>
Subject: Re: [CBQ] Speaking of Shovel noses..
Resent-From: <Dave_Lotz@bellsouth.net>
Resent-Date: Thu, 11 Jun 2026 13:10:54 -0700

 

Brian,

 

This is tricky. You need to GENTLY spread one end of the body while twisting the floor to remove it.  It’s been a minute since I did this with my Mark Twain Zephyr. The brass body will spring back after the GENTLE spreading.

 

Dave Lotz

 

From: CBQ@groups.io <CBQ@groups.io> On Behalf Of BRIAN PAUL EHNI via groups.io
Sent: Thursday, June 11, 2026 3:11 PM
To: CBQ groups.io <CBQ@groups.io>
Subject: [CBQ] Speaking of Shovel noses..

 

I’m trying to install an ESU sound/DCC controller in my Challenger “Texas Rocket” #9901. I can’t figure out how to get the chassis out. I’ve removed all visible screws and hold downs. The chassis slides in the shell, and I can lift one edge up, but I can’t get it past the curved part of the side sills.

 

A little help?

 

 

Thanks!
--

Brian Ehni

 

 

Virus-free.www.avast.com

_._,_._,_

---

Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#68377) | Reply to Group | Reply to Sender | Mute This Topic | New Topic
Your Subscription | Contact Group Owner | Unsubscribe [archives@nauer.org]

_._,_._,_