RE: [CBQ] Question: handcar shed

["Nelson Moyer npmoyer@hotmail.com [CBQ]" <CBQ@yahoogroups.com>]

Rupert,

 

Please upload the drawing so the rest of us can have access to it as well. I joined BRHS long after Zephyr #14 was published, and it’s out of print.

 

Nelson Moyer

 

From: CBQ@yahoogroups.com [mailto:CBQ@yahoogroups.com]
Sent: Saturday, March 25, 2017 11:12 PM
To: CBQ@yahoogroups.com
Subject: RE: [CBQ] Question: handcar shed

 

Sam

Drawing 97789 of a Signal Maintainer’s Four-Stall Motor Car House appeared in Zephyr 14 – I’ll send you a copy.

Rupert Gamlen
Auckland NZ

 

---

From: CBQ@yahoogroups.com [mailto:CBQ@yahoogroups.com]
Sent: Sunday, 26 March 2017 4:37 p.m.
To: CBQ@yahoogroups.com
Subject: Re: [CBQ] Question: handcar shed [1 Attachment]

 

[Attachment(s) from STEVEN HOLDING included below]

Sam

Clearance Diagram Plan No. 43437G dated 5/6/20 does not show for a tool shed but if depends on which state you are in

Missouri shows 16 feet

Drawing 86666 6/30/45  Grading and dressing for CTC Instrument and Shelter House shows 14 ft from near rail

I think the society reprinted Drawing 97789 Signal Maintainers 4 stall motor car house.  I have it in my Standard Plan Notebook but can not find on the BRHS Index(I have trouble with computer index and prefer to thumb thru the pages)

A lot of standard structures were pre-fabbed at Havelock using recycled materials 97789 is for a four stall 10 X 29'6" but could have just as well been built cut in half with one stall and a tool shed.  If I remember right there use to be one behind the tower at Aurora used to store both maintainer and inspector cars.

I tried to scan it and send 97789 IF it does not work will take to Dave's Next weekend and I know he can send it

Steve in SC

 

 

On Saturday, March 25, 2017 1:17 PM, "Sam Cook trains@sjcook.com [CBQ]" <CBQ@yahoogroups.com> wrote:

 

 

What is the standard distance from rail to front of a handcar shed?
We know ours is not correct and we are considering re-doing it.
(Plus, it is falling down.)
http://sullivanhistory.org/depot/platform/toolshed/index.htm
Anyone have a good company drawing of a standard shed?
Thanks.
Sam Cook, Facilities Manager
Sullivan County (MO) Historical Society, Milan, MO

 

 

 

__._,_.___

---

Posted by: Nelson Moyer <npmoyer@hotmail.com>

---

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___