|
Aaron: You are correct. The major cross bearing pieces should line up with the door posts. The smaller ones, usually an "I" or Channel cross-section, attached to the side sill where the angled "Z" braces and vertical braces meet. The problem, which you have illustrated, is that the offset doors on the Q double door and one and one-half door cars do not line up with the generic under frame of the kit. By matching the under frame braces to the Truss-arrangement supporting the sides, the Burlington achieved structural integrity that allowed these home-built cars to have extraordinary service lives. Jim Sandriin On Sat, 8 Jun 2019 at 11:40, npin53 <npin53@hotmail.com> wrote: What is the proper cross tie and cross bearer arrangement on a XA-11A. They should line up with the rivets on the side sill. Thank you for any assistance. _._,_._,_
Groups.io Links: You receive all messages sent to this group.
View/Reply Online (#57484) |
Reply To Group
| Reply To Sender
|
Mute This Topic
| New Topic _._,_._,_
|