Re: [CBQ] CB&Q PC-6 Chair Car Photos

["Nelson Moyer" <npmoyer@hotmail.com>]

Yes, both diagram books and the photo book. One of the difficulties I’m having is that the drawings don’t always show grab irons, and when they do, they’re not drawn to scale. Tom’s instructions just say, ‘install grab irons’. No length or position information. I have to rely on photos for grab irons and vent sizes and locations.

 

Nelson

 

From: CBQ@groups.io [mailto:CBQ@groups.io] On Behalf Of Dave Lotz
Sent: Thursday, April 16, 2020 3:42 PM
To: CBQ@groups.io
Subject: Re: [CBQ] CB&Q PC-6 Chair Car Photos

 

Nelson,

 

Do you have Bill Glick’s Passenger Car books?

 

Dave

 

From: CBQ@groups.io <CBQ@groups.io> On Behalf Of Nelson Moyer
Sent: Thursday, April 16, 2020 4:36 PM
To: CBQ@groups.io
Subject: [CBQ] CB&Q PC-6 Chair Car Photos

 

I’m starting to build a CB&Q heavyweight PC-6 chair car, and the only two photos I have are 4500 from the Glick photo book and 4552 (modified) from an unknown source. Both photos are the large pressurized water tank side. It would be very helpful to get a photo of the brake cylinder side, particularly for the clerestory vent, underbody equipment arrangements. Also, roof type (both ribbed and smooth roofs were used), and truck type (kit instructions state either 5H, 5K, or 5M were used). Web searches have come up negative.  The series numbers for unmodified PC-6 chair cars are 4500-4501, 4504-4507, and 4514. Any and all photos appreciated.

 

Nelson Moyer

 

---

This email has been checked for viruses by Avast antivirus software. www.avast.com

_._,_._,_

---

Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#59379) | Reply To Group | Reply To Sender | Mute This Topic | New Topic

Your Subscription | Contact Group Owner | Unsubscribe [archives@nauer.org]

_._,_._,_